How To Restart A Gas Water Heater
How To Restart A Gas Water Heater. If the gas was shut down on purpose such as for the winter it is very, very safe to go to your manual for your furnace and water heater and turn on the switch, relight the pilot and turn on your thermostat. This may require you to rotate and open the cold and hot water valves so they are parallel to the position of the main valve.
This may require you to rotate and open the cold and hot water valves so they are parallel to the position of the main valve. All you need to do now. A water heater reset button, usually red, is located in the center of the limit switch just above the water heater thermostat.
It’s Easy To Turn Your Water Heater Pilot Back On.let Go Of The Red Control Buttonlet The Water Heater Sit For 5 Minutes To Release Gas From The System;Lift Off Or Unsnap Any Access Cover That Blocks Access To The Burner.
Turn the water heater's gas valve switch to the off position, wait for a few seconds and then flip the switch to the on position to reset the system. The water heater's gas valve is located near the bottom of the unit and connects to your home's natural gas line. Turn the water heater's gas valve switch to the off position, wait for a few seconds and then flip the switch to the on position to reset the system.
It Is Most Likely A Foam Pad That Covers Up The Reset Button As Well As Other Controls Present In Your Water Heater.
The water heater limit switch is a safety device that will shut the power down to the water heater if something malfunctions and the water gets to hot. Refer to the manufacturer’s manual for exact instructions on how to safely restart your water heater. Before diving into how to reset hot water heater, we should.
Lighting A Water Heater Pilot Light At A Glance.
The water heater's gas valve is located near the bottom of the unit and connects to your home's natural gas line. Remove the inlet filter and wash it under the running water with the help of a brush. Videos you watch may be added to the tv's watch history and influence tv recommendations.
All You Have To Do Is Pull The Pad Out Of The Way And The Reset Button Should Be Visible.
Thermostats aren’t the only parts on an electric water heater that can wear out and trip the reset button, especially if you’re finding you have to reset the water heater frequently or you run out of hot water fast and often. All you need to do now. Remove the foam insulation pad behind the plate, then press and hold the reset button.
Typically, This Will Be Under The Gas Valve.
This switch breaks the circuit and saves the water heater from abnormal conditions. The a.o smith water heater reset button on a gas or electric version can be found under the metal cover close to the middle of the unit. Turn off the device for 30 minutes and then restart it.